Sound Skulptor forums

Build help and troubleshooting => TS500 Tape Simulator => Topic started by: Amek on July 02, 2021, 02:48:13 PM

Title: TS500 different version out of phase?
Post by: Amek on July 02, 2021, 02:48:13 PM

Hello everybody,
one question:
I Have two TS500 of two different versions: the first one REV 1.3 and the second one REV 1.5, the older one REV 1.3, when inserted in "ON" inverts the polarity of the input signal, in "OFF" does not,  while the newer one, REV 1.5 does not: is this normal? How can I get both without polarity inversion?
Thank you very much
Amek

Title: Re: TS500 different version out of phase?
Post by: JPK on July 05, 2021, 11:28:45 AM

You are correct, the previous version inverted the phase. This is corrected in the current version.
It is possible to restore the phase in the previous version with a modification described in the attached pdf.

Title: Re: TS500 different version out of phase?
Post by: aktivomat on October 21, 2023, 03:19:21 PM

Hey JPK!

I think I have the same phase issue (REV 1.4). Could you please upload the modification pdf again?

Thank you very much and kind reagards!

Title: Re: TS500 different version out of phase?
Post by: JPK on October 23, 2023, 05:51:37 PM

Here it is

Title: Re: TS500 different version out of phase?
Post by: aktivomat on October 24, 2023, 09:28:19 PM

Great! Thank you 👌! Just to be on the save side… REV 1.4 is certainly affected by the problem, right?

Title: Re: TS500 different version out of phase?
Post by: JPK on October 25, 2023, 09:21:31 AM

Right, it was corrected in REV1.5.