Sound Skulptor forums
Build help and troubleshooting => LA502 Optical Compressor => Topic started by: Sam on April 24, 2022, 01:30:28 PM
-
This might be a stupid question, but the LA502 is my first real solder project, so I'm not very experienced: On the RLY1, do I need to solder all pins to the board? Because there are two pins that look like they aren't meant to be soldered (the two closest to the edge connector of the PCB board). I am assuming they are just extra holes so the relay fits into the board. But since there is no mention of them in the documentation, I just wanted to make sure that I am correct in this assumption. Thanks!
-
Those two pins are just for stability. Solder the remaining 6 and you’re good to go.
-
Awesome, thanks a lot!