Sound Skulptor forums

Build help and troubleshooting => MP573 Microphone preamplifier => Topic started by: b.riesel on July 08, 2022, 10:39:24 AM

Title: MP 573 - no output anymore
Post by: b.riesel on July 08, 2022, 10:39:24 AM
Hi Jean-Pierre
I finished my MP 573 an did the setup as discribed. Everything was as it should. I did some testrecording with all kind of mics and the DI. Everything was really great sounding.
Next step was to connect the MP with my EQ573II. But this didn´t work. I tried a bit and decided to run both units separately for the moment. The EQ still works perfect, but the MP now dosn´t have any output. I can see the Input-LED reacting on the signal i feed it with. That seems to be normal. With more Gain the LED stays green, when lowering, it only lights up, when there is a hotter signal.
But on the output there is nothing.
I tried different slots of my Bento-Case, also the one, where my EQ573 is running without issues. 
Now I have no Idea what to do next. Can you give me some support?
Thank you so much in advance,
best regards
Stefan
Title: Re: MP 573 - no output anymore
Post by: JPK on July 09, 2022, 09:29:51 AM
Did you think to put the jumper back on CN1 after disconnecting the EQ?
Check that it is still making a good connection.
Title: Re: MP 573 - no output anymore
Post by: b.riesel on July 11, 2022, 07:42:39 PM
Hi Jean-Pierre
That was easy...sorry...I completely forgot that I removed the jumper...everything is fine now!
thank you!