hello...
I am build a mc624 for a friend... he bought it some time ago..
Followed you instructions... and have a couple of problems... hope you can help me..
1-. the kit came with 6 opa2134 and 3 lm4562na... can you please tell what position they go in and if i need any other special procedure for these opamps??
2-. Switcher built and voltages ok
built main board and front panel everything was great... ..
When starting with the setup guide with only TL1206 opamps soldered I got +5v on the -16v rail.. all other voltages OK. checked for soldering problems and didn´t find any...
I unsoldered the lt1206 and now I get -17.7v with no opamps.. If I put the LT1206 back in the circuit... my negative voltage goes to +5v ..
seems I might have burnt the lt1206.. how can I check the opamp?? do you have some voltage table to check what is wrong??
thank you
