[UrbanOsterman]

Questions about Using a Two-slot 500 module.
When using a 1-slot modules in a chain of modules and passing signal from one module to next module
is normally working OK in a 500-Host (using switches on the back).

But when we are using a 2-slot module such as the CP554, as part of the signal-chain,
we are running into a problem.
Both input and output connectors are on the leftmost PCB.
Using the input and output connectors on the back of the host works OK.
So we could use short cables on the back.

How can this be solved if I want to use the Host forward-switches instead.

Regards
Urban Osterman

[JPK]

This will work from the left module to the CP554 input but it won't work CP554 output to right module input because the right side connector output is not connected.
You must use an external connector here.
On the other hand, the stereo link does work.