Author Topic: High pass not working EQ573-II

October 10, 2024, 05:29:33 PM
Read 92 times

Dolbah

  • Jr. Member
  • **
  • Posts: 75
  • Karma: +0/-0
    • View Profile
High pass stopped working on my EQ573-II. I have two units, and switched the mainboard between them. The problem follows the mainboard.

When turning the knob the sound just flickers on each step, but no  noticable change in the frequency spectrum. 

Any idea where to start? I have reflowed all nearby joints and then some.

October 11, 2024, 11:27:05 AM
Reply #1

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1115
  • Karma: +37/-0
    • View Profile
Maybe a bad solder joint on inductor L1.
JPK

October 12, 2024, 07:09:56 PM
Reply #2

Dolbah

  • Jr. Member
  • **
  • Posts: 75
  • Karma: +0/-0
    • View Profile
Thanks! I actually misinterpreted the problem, by testing a tone with to little lowend. The actuall problem is that the unit that did not react as originaly described. actually is ok, but the other one is shaving off 3dB on all highs, when set to Hipass 360. It gradually lowers for each step on the high-pass.

« Last Edit: October 13, 2024, 01:00:57 PM by Dolbah »

October 16, 2024, 03:59:42 PM
Reply #3

JPK

  • Administrator
  • Hero Member
  • *****
  • Posts: 1115
  • Karma: +37/-0
    • View Profile
Check the values and solder joints of R26, R27, R9, J6a, J6b, C13...C22, L1, RN1, RN2.
JPK

October 17, 2024, 08:29:52 PM
Reply #4

Dolbah

  • Jr. Member
  • **
  • Posts: 75
  • Karma: +0/-0
    • View Profile
Check the values and solder joints of R26, R27, R9, J6a, J6b, C13...C22, L1, RN1, RN2.
thank you! it was somewhere on that route :) All ok now