[AbYdIy-28]

Hello, 
When assembling the mic pre I accidentally soldered the part J1a in backwards and damaged it when I got it out, where would i be able to get that part at? 

[JPK]

Mouser/Digikey PH2RA-10-UA

[AbYdIy-28]

Thank you for the part #, I just installed the new part and when I power it up the clip light stays red. No controls do anything. Before I installed the new J1a part everything appeared to work, the only thing that didn't work was the output potentiometer. Your help would be greatly appreciated. Thanks 

[JPK]

could it be that you damaged the pcb when removing J1a?
Check that, for each pin of J1a, the top and bottom pads are still connected.

[AbYdIy-28]

I got everything working, I was able to solder the pins on both sides to the PCB and get the pre amp working, Thanks!